Intel B940 Datasheet Page 63

  • Download
  • Add to my manuals
  • Print
  • Page
    / 360
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 62
Datasheet, Volume 2 63
Processor Configuration Registers
2.7.25 ERRCMD—Error Command Register
This register controls the processor responses to various system errors. Since the
processor does not have an SERR# signal, SERR messages are passed from the
processor to the PCH over DMI.
When a bit in this register is set, a SERR message will be generated on DMI whenever
the corresponding flag is set in the ERRSTS register. The actual generation of the SERR
message is globally enabled for Device 0 using the PCI Command register.
B/D/F/Type: 0/0/0/PCI
Address Offset: CA–CBh
Reset Value: 0000h
Access: RO, RW
Bit Attr
Reset
Value
Description
15:12 RO 0h Reserved
11 RW 0b
SERR on Processor Thermal Sensor Event (TSESERR)
1 = The processor generates a DMI SERR special cycle when bit 11 of the
ERRSTS is set. The SERR must not be enabled at the same time as the
SMI for the same thermal sensor event.
0 = Reporting of this condition using SERR messaging is disabled.
10 RO 0b Reserved
9RW 0b
SERR on LOCK to non-DRAM Memory (LCKERR)
1 = The processor will generate a DMI SERR special cycle whenever a
processor lock cycle is detected that does not hit DRAM.
0 = Reporting of this condition using SERR messaging is disabled.
8RW 0bReserved
7:2 RO 0h Reserved
1RW 0bReserved
0RW 0bReserved
Page view 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 359 360

Comments to this Manuals

No comments