Pentium
®
II Processor at 350 MHz, 400 MHz, and 450 MHz
18 Datasheet
NOTES:
1. These resistor values are recommended for system implementations using open-drain CMOS buffers.
2. ~150
Ω
resistors are expected for these signals. This value may vary by system and should be correlated with the output
drive characteristics of the devices generating the input signals. Other approximate values are recommended for proper
operation with the Pentium
®
II processor Logic Analyzer Interface.
3.
TRST# must be
ulled to
round via a 680
Ω
resistor or driven low at
ower on with the assertion of RESET#
(see
Table 19).
4. 1K
−
10K
Ω
pullup to 2.0 V (V
CC
CORE
) or, if 2.5 V ramps after core, pull up TESTHI to 2.5V (V
CC
2.5
) with a 100 k
Ω
resistor.
The groups and the signals contained within each group are shown in Table 3. Refer to Section 7.0
for descriptions of these signals.
Table 2. Recommended Pull-up Resistor Values (Approximate) for CMOS Signals
1, 2, 3
Recommended Resistor
Value (A
roximate) CMOS Si
nal
150
Ω
TDI, TDO, TMS, PICD[0], PICD[1]
150
Ω
– 220
Ω
FERR#, IERR#, THERMTRIP#
150
Ω
– 330
Ω
A20M#, IGNNE#, INIT#, LINT[1]/NMI, LINT[0]/INTR, PWRGOOD, SLP#, PREQ#
410
Ω
STPCLK#, SMI#
500
Ω
FLUSH#
1K
Ω
–100K
Ω
TESTHI
4
Comments to this Manuals