Intel ISP1100 User Manual download pdf (Page 44)

44 Intel ISP1100 Internet Server Product Guide

Installing PCI Add-in Card(s)

This procedure describes how to install the PCI add-in card(s) in the server expansion slots. The

vertically mounted riser card accommodates one standard (left side) and one low-profile (right side)

PCI add-in card. Before proceeding, be sure you are thoroughly familiar with the information in

“Before You Begin” at the front of this chapter.

NOTE

If applicable, check that the add-in card jumpers or switches are set

according to the manufacturer’s instructions before proceeding.

Removing the Riser Card

Perform this procedure to remove the riser card from the server board. Refer to Figure 24 while

performing this procedure.

NOTE

This procedure assumes that the PCI add-in cards have been removed from

the server chassis as described in the previous “Removing the PCI Add-in

Card(s)” procedure.

1. Grasp the riser card at each end (A) and gently rock and lift the riser card until it releases from

the server board connector (B).

2. Remove the riser card from the server board.

OMO9437

Figure 24. Removing the Riser Card

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 80 81

No comments

Intel ISP1100 User Manual Page 44