Intel ISP1100 User Manual download pdf (Page 35)

Removing/Installing Server Components 35

Installing the Hard Drive(s)

This procedure describes how to install hard drives in the server drive bays. Before proceeding, be

sure you are thoroughly familiar with the information in “Before You Begin” at the front of this

chapter.

Installing the Hard Drive in the Mounting Bracket

Perform this procedure to install the hard drive in the mounting bracket. Refer to Figure 15 while

performing this procedure.

NOTE

This procedure assumes that the mounting bracket has been removed from

the drives as described in the previous “Removing the Hard Drives”

procedure.

1. Place the drive in the mounting bracket with the component side down and the front of the

drive facing the front (tabbed) end (A) of the mounting bracket.

2. Align the four mounting bracket screw holes (B) with the mating holes (two on each side) in

the drive housing.

3. Use a Phillips screwdriver and four screws (C) to securely attach the mounting bracket to the

drive. Do not overtighten the screws because the bracket sides can bend inward which affects

the alignment of the tabs with the slots in the front panel.

OMO9454

Figure 15. Installing the Hard Drive in the Mounting Bracket

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 80 81

No comments

Intel ISP1100 User Manual Page 35