Intel SDS2 User Manual download pdf (Page 106)

Jumpers Intel® Server Board SDS2

Revision 1.2

Order Number: A85874-002

Table 80. List of Assembled Jumpers in Production

Jumper Pins Default Operation

1 – 2 Open When closed, clears CMOS during POST

3 – 4 Open When closed, clears CMOS password

5 – 6 Open RESERVED (Do Not Use)

7 – 8 Open RESERVED (Do Not Use)

9 – 10 Open When closed, forces BIOS Recovery Mode

CN42

11 – 12 Closed SPARE jumper storage

CN46 1 – 2 Open When closed, permits BIOS boot block to be updated

CN47 1 – 2 Open When closed, permits BMC boot block to be updated

CN48 1 – 2 Open When closed, disables FRB timer

CN49 1 – 2 Open When closed, forces BMC in Update Mode

CN50 1 – 2 Closed When closed, disables chassis intrusion sensor

9.2 Performing CMOS Clear, BIOS Recovery, and BMC Force

Update

9.2.1 Performing CMOS Clear

Clear CMOS as follows.

1. Power off the system, unplug the power cord, and remove the chassis panel.

2. Add a jumper on CN42 pins 1-2 (CMOS Clear).

3. Replace the chassis panel, plug in the power cable(s), and power on the system.

4. After POST completes, power down the system, unplug the power cable(s), and remove

the chassis panel.

5. Remove the jumper from CN42 pins 1-2.

6. Replace the chassis panel and connect system cables.

7. Power on the system, press F2 at the prompt to run the BIOS Setup utility, and select

“Get Default Values” at the Exit menu.

9.2.2 Performing BIOS Recovery Boot

In the event of BIOS corruption, the following procedure may be used to perform a BIOS

Recovery boot.

1. Prepare a bootable floppy diskette containing the BIOS recovery files for the SDS2

Server Board obtained from Intel’s web sites.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 144 145

No comments

Intel SDS2 User Manual Page 106