Intel R1304BTSSFAN Datasheet Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 67
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN TPS 250W Power Subsystem
Revision 2.0 15
Intel order number G17455-004
OFF for 15sec min (with +5VSB/0.1A) and a PSON# cycle HIGH for 1sec shall be able to reset
the power supply.
3.8.1 Over Current Protection (OCP)
Each output shall have individual OCP protection circuits. The PSU shall shutdown and latch off
after an over current condition occurs. Whereas OCP of +5VSB shall turn the power supply into
“hiccup mode” until the OCP condition removed. The values are measured at the PSU harness
connectors and shall not be damaged from repeated power cycling in this condition. There shall
be current sensors and limit circuits to shut down the entire power supply if the limit is
exceeded. The limits are listed below.
Table 11. Over Load Protection (OCP) Limits
Output Voltage Continuous Load
Current Limit MIN Current Limit MAX
+12V
23A 25A
+5V
14.4 A 25A
+3.3V
15A 30A
-12V
4A
+5VSB
4.5A
3.8.2 Over Voltage Protection (OVP)
Each output shall have individual OVP protection circuits built in and it shall be locally sensed.
The PSU shall shutdown and latch off after an over voltage condition occurs. The output
voltages are measured at the harness connectors. The voltage shall never exceed the
maximum levels when measured at the power pins of the output harness connector during any
single point of fail.
The voltage shall never trip any lower than the minimum levels when
measured at the power pins of the connector.
Table 12. Over Voltage Protection (OVP) Limits
Output Voltage OVP MIN (V) OVP MAX (V)
+3.3V 3.7 4.5
+5V 5.6 6.5
+12V 13.3 15.6
-12V -13.3 -15.6
+5VSB 5.6 6.5
3.8.3 Over Temperature Protection (OTP)
The power supply shall be protected against over temperature conditions caused by loss of fan
cooling or excessive ambient temperature. In an OTP condition the PSU will shut down. When
the power supply temperature drops to within specified limits, the power supply shall restore
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 66 67

Comments to this Manuals

No comments