Intel Core 2 Duo User Manual download pdf (Page 27)

Intel

Core

2 Duo Processor and Intel

Q35 Express Chipset Development Kit

October 2007 User’s Manual

Order Number: 318476001US 27

Setting Up and Configuring the Development Kit—Intel Core 2 Duo Processor and Intel Q35

Express Chipset

environment. Since the board is not in a protective chassis, the user is required to

observe extra precautions when handling and operating the system.

The board is a standard uBTX form factor and provides non-plated mounting holes with

top and bottom ground rings. If the board is not going to be used in a chassis,

standoffs are included for bench top use in the lab environment.

The development kit includes eight hex standoffs and for screws to attach to the board

for bench top use. Four of the standoffs are used to mount the heatsink (refer to

Section 3.3 for heatsink installation). Attach standoffs to the screws to the board at the

following mounting hole locations.

1. Insert screw through top mounting hole for the BTX Heatsink. Refer to Figure 17 for

the mounting hole location.

2. Place standoff on backside of board and hand tighten to screw. Refer to Figure 18

for guide.

3. Repeat for additional standoffs on the board until all standoffs are installed. Refer

to Figure 17 for recommended mounting hole locations.

Figure 17. Mounting Hole Locations

J24LB

Recommended

Mounting Hole

Locations

Mounting Hole for

BTX heatsink

Locations

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

No comments

Intel Core 2 Duo User Manual Page 27