Intel BLKDH61CR Datasheet download pdf (Page 54)

Intel Desktop Board DH61CR Product Guide

The three-pin BIOS jumper block enables board configuration to be done in the BIOS

Setup program. Table 14 shows the jumper settings for the BIOS Setup program

modes.

Table 14. Jumper Settings for the BIOS Setup Program Modes

Jumper Setting Mode Description

Normal (default) (1-2) The BIOS uses the current configuration and

passwords for booting.

Configure (2-3) After the Power-On Self-Test (POST) runs, the

BIOS displays the Maintenance Menu. Use this

menu to clear passwords.

Recovery (None) The BIOS recovers data in the event of a failed

BIOS update.

Clearing Passwords in the BIOS Setup

Program

This procedure assumes that the board is installed in the computer and the

configuration jumper block is set to normal mode.

1. Observe the precautions in "Before You Begin" on page 29.

2. Turn off all peripheral devices connected to the computer.

Turn off the computer.

Disconnect the computer’s power cord from the AC power source (wall outlet or

power adapter).

3. Remove the computer cover.

4. Find the configuration jumper block (see Figure 23).

5. Place the jumper on pins 2-3 as shown

below.

6. Replace the cover, plug in the computer, turn on the computer, and allow it to

boot.

7. The computer starts the Setup program. Setup displays the Maintenance menu.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 79 80

No comments

Intel BLKDH61CR Datasheet Page 54