Intel BLKDH61CR Datasheet download pdf (Page 40)

Intel Desktop Board DH61CR Product Guide

To install a DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 29.

2. Turn off all peripheral devices connected to the computer.

Turn off the computer

and disconnect the AC power cord.

3. Remove the computer’s cover and locate the DIMM sockets (see Figure 15).

4. If

a fu

ll length PCI Express graphics card is installed in the PCI Express x16

connector, remove the card to gain full access to the DIMM sockets.

Figure 15. Installing a DIMM

5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the

open position.

6. Holding the DIMM by the edges, remove it from its anti-static package.

7. Position the DIMM above the socket. Align the small notch at the bottom edge of

the DIMM with the keys in the socket (see inset in Figure 15).

8. In

sert

the bottom edge of the DIMM into the socket.

9. When the DIMM is inserted, push down on the top edge of the DIMM until the

retaining clips snap into place. Make sure the clips are firmly in place.

10. Reinstall the PCI Express graphics card if one was removed in Step 4.

11. Replace the computer’s cover and reconnect the AC power cord.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 79 80

No comments

Intel BLKDH61CR Datasheet Page 40