Intel ICH10R User Manual download pdf (Page 30)

2-7 Starting Up Your Computer

1. After all connection is made, close your computer case cover.

2. Be sure all the switch are off, and check that the power supply input voltage is set to

proper position, usually in-put voltage is 220V∼240V or 110V∼120V depending on your

country’s voltage used.

3. Connect the power supply cord into the power supply located on the back of your system

case according to your system user’s manual.

4. Turn on your peripheral as following order:

a. Your monitor.

b. Other external peripheral (Printer, Scanner, External Modem etc…)

c. Your system power. For ATX power supplies, you need to turn on the power

supply and press the ATX power switch on the front side of the case.

5. The power LED on the front panel of the system case will light. The LED on the

monitor may light up or switch between orange and green after the system is on. If it

complies with green standards or if it is has a power standby feature. The system will

then run power-on test. While the test are running, the BIOS will alarm beeps or

additional message will appear on the screen.

If you do not see any thing within 30 seconds from the time you turn on the power. The

system may have failed on power-on test. Recheck your jumper settings and connections

or call your retailer for assistance.

Beep Meaning

One short beep when displaying logo No error during POST

Long beeps in an endless loop No DRAM install or detected

One long beep followed by two short

beeps

No VGA card found or error found in monitor

High frequency beeps when system is

working

CPU overheated

System running at a lower frequency

6. During power-on, press <Delete> key to enter BIOS setup. Follow the instructions in

BIOS SETUP.

Power off your computer:

You must first exit or shut down your operating system

before switch off the power switch. For ATX power supply, you can press ATX power

switching after exiting or shutting down your operating system. If you use Windows 9X,

click

“Start”

button, click

“Shut down”

and then click

“Shut down the computer?”

The power supply should turn off after windows shut down.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

Comments to this Manuals

No comments

Intel ICH10R User Manual Page 30

Comments to this Manuals

Related products and manuals for Motherboards Intel ICH10R