Intel ICH10R User Manual download pdf (Page 24)

2-6 Connectors, Headers

2-6-1 Connectors

(1) Power Connector (24-pin block): ATXPWR1

ATX Power Supply connector: This is a new defined 24-pins connector that usually

comes with ATX case. The ATX Power Supply allows using soft power on momentary

switch that connect from the front panel switch to 2-pins Power On jumper pole on the

motherboard. When the power switch on the back of the ATX power supply turned on,

the full power will not come into the system board until the front panel switch is

momentarily pressed. Press this switch again will turn off the power to the system

board.

** We recommend that you use an ATX 12V Specification 2.0-compliant power supply

unit (PSU) with a minimum of 350W power rating. This type has 24-pin and 4-pin

power plugs.

** If you intend to use a PSU with 20-pin and 4-pin power plugs, make sure that the 20-pin

power plug can provide at least 15A on +12V and the power supply unit has a minimum

power rating of 350W. The system may become unstable or may not boot up if the

power is inadequate.

(2) ATX 12V Power Connector (8-pin block) : ATX12V1

This is a new defined 8-pin connector that usually comes with ATX Power Supply. The

ATX Power Supply which fully supports LGA 1366 processor must including this

connector for support extra 12V voltage to maintain system power consumption.

Without this connector might cause system unstable because the power supply can not

provide sufficient current for system.

Pin 1

ROW1 ROW2

24-Pin

ROW1 ROW2

Pin 1

20-Pin

PIN ROW1 ROW2

1 3.3V 3.3V

2 3.3V -12V

3 GND GND

4 5V Soft Power On

5 GND GND

6 5V GND

7 GND GND

8 Power OK -5V

9 +5V (for Soft Logic) +5V

10 +12V +5V

11 +12V +5V

12 +3V GND

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 53 54

No comments

Intel ICH10R User Manual Page 24