Intel MD566X User Manual download pdf (Page 54)

56K V.92 Data, Fax, and Voice Chipset

54 Intel Confidential Programmer’s Guide

&Yn 0

Select Stored Profile on Power-up: This command selects the particular

stored user profile from the NVRAM to be loaded into the active profile upon

modem power-up.

n = 0** Select profile 0

n = 1 Select profile 1

&Zn=x none

Store Telephone Number: This command stores a telephone number up to

30 digits (including dial modifiers) in the NVRAM. To dial the stored tele-

phone number, use the ATDS=n command. Use the

&V command to see the

stored telephone number.

n = 0–3

x = 0–9 A B C D # * T P R W @ , ! ;

%En 1

Auto-Retrain Control: This command controls whether the modem auto-

matically initiates a modem retrain whenever the received data signal quality

falls below a threshold that may affect data reliability. The value for ‘n’ is

stored in the NVRAM.

n = 0 Disabled

n = 1** Enabled

%Gn 1

Rate Renegotiation: This command selects whether the modem automatically ini-

tiates a change to a higher speed or lower speed depending on received signal qual-

ity (that is, rate negotiation). The modem always responds to any rate change initi-

ated by the remote modem.

n = 0 Disabled

n = 1** Enabled

Table 3-4. Data Mode Command Descriptions (Continued)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 129 130

No comments

Intel MD566X User Manual Page 54