Intel D425KT User Manual download pdf (Page 28)

Intel Desktop Board D425KT Product Guide

Installing and Removing Memory

NOTE

To be fully compliant with all applicable Intel SDRAM memory specifications, the

boards require DIMMs that support the Serial Presence Detect (SPD) data structure.

The Desktop Board has two 204-pin DDR3 SO-DIMM sockets that support up to 4 GB

of system memory. To install system memory on the Desktop Board, see Figure 7 and

follow these steps:

1. Observe the precautions in "Before You Begin" on page 23.

2. Install the fi

rst DI

MM (Figure 7, A) in the bottom (DIMM 0) socket. Align the notch

in the DIM

M with the key in the socket (Figure 7, B), while holding the DIMM with

the back edge t

ilted slightly upwards, insert it in the socket, and gently push the

back edge down until it snaps into the retention arms (Figure 7, C).

3. If

you are in

stalling a second DIMM, repeat Step 2 using the top (DIMM 1) socket

(Figure 7, D).

Figure 7. Installing System Memory

To remove an SO-DIMM from a socket, gently spread the socket’s retention arms

(Figure 7, C) to disengage them from the SO-DIMM.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

No comments

Intel D425KT User Manual Page 28