Intel S5000XVNSASR User's Guide

Intel® Workstation Board S5000XVN User GuideA Guide for Technically Qualified Assemblers of Intel® Identified Subassemblies/ProductsIntel Order Numbe

x Intel® Workstation Board S5000XVN

xiContentsSafety Information ... iiiImportant Safety

xiiClearing the Password ... 24Clearing the CMOS

xiiiElectromagnetic Compatibility Notices ...57FCC (USA) ...

xiv

xvList of FiguresFigure 1. Intel® Workstation Board S5000XVN... 1Figure 2. Conne

xvi

xviiList of TablesTable 1. Additional Information and Software ...viiiTable 2.

xviii

1 Workstation Board FeaturesThis chapter briefly describes the main features of the Intel® Workstation Board S5000XVN. This chapter provides a photogr

ii Intel® Workstation Board S5000XVNDisclaimer Information in this document is provided in connection with Intel® products. No license, express or imp

2 Intel® Workstation Board S5000XVNTable 2 summarizes the features of the workstation board.Table 2. Workstation Board FeaturesFeature DescriptionProc

Intel® Workstation Board S5000XVN 3Hard drive and optical drive support• Optical devices are supported• Ultra ATA-100 support: One IDE channel that is

4 Intel® Workstation Board S5000XVNConnector and Header LocationsFigure 2. Connector and Component LocationsManagement support • Support for the Intel

Intel® Workstation Board S5000XVN 5A. PCI-X* 64-bit, 100-MHz slot 1P. Processor 1 socket EE. Enclosure management SAS SES (available only with product

6 Intel® Workstation Board S5000XVNConfiguration JumpersJumper Name Pins What Happens at System ResetBIOS Bank Select(J1C3)1 - 2 Bank 0: Boot to an al

Intel® Workstation Board S5000XVN 7Figure 3. Configuration JumpersPassword Clear(J1D2)1 - 2 Protect password: These pins should be jumpered for normal

8 Intel® Workstation Board S5000XVNIntel® Light-Guided DiagnosticsThe workstation board contains diagnostic LEDs to help you identify failed and faili

Intel® Workstation Board S5000XVN 9Callout LED FunctionA. Bit 3 LED POST LED. The sequence of lit POST LEDs is used to identify specific errors that m

10 Intel® Workstation Board S5000XVNL. DIMM B2 fault LED This LED indicates a fault has occurred with the FBDIMM installed in socket DIMM_B2. Replace

Intel® Workstation Board S5000XVN 11Back Panel FeaturesThe diagram and table show the back panel connectors and LEDs. For information about the LEDs,

Safety InformationImportant Safety InstructionsRead all caution and safety statements in this document before performing any of the instructions. See

12 Intel® Workstation Board S5000XVNRAID SupportThe Intel® Workstation Board S5000XVN is available in SATA models and a SAS models. • The SATA model h

Intel® Workstation Board S5000XVN 13SAS Workstation BoardIn addition to the SATA features described above, SAS models of the workstation board (produc

14 Intel® Workstation Board S5000XVNAudio SupportThe Intel® Workstation Board S5000XVN includes the Realtec* ALC260 2-channel high-definition audio co

Intel® Workstation Board S5000XVN 15Hardware RequirementsTo avoid integration difficulties and possible board damage, your system must meet the requir

16 Intel® Workstation Board S5000XVNSee the following diagram to identify the DIMM sockets.Figure 5. DIMM SocketsCallout DIMM Socket Callout DIMM Sock

Intel® Workstation Board S5000XVN 17A minimum of one 512 MB FBDIMM is required in DIMM socket DIMM_A1. FBDIMMs must meet the following requirements:•

18 Intel® Workstation Board S5000XVNOptional HardwareIntel® RAID Activation KeyThe Intel® RAID Activation Key AXXRAKSW5 can be purchased and installed

2 System UtilitiesUsing the BIOS Setup UtilityThis section describes the BIOS Setup Utility options, which is used to change system configuration defa

20 Intel® Workstation Board S5000XVNSetup MenusThe BIOS Setup utility provides multiple pages to allow you to view and change system settings. Some pa

Intel® Workstation Board S5000XVN 21Upgrading the BIOSThe upgrade utility allows you to upgrade the BIOS in flash memory. The code and data in the upg

iv Intel® Workstation Board S5000XVN重要安全指导 在执行任何指令之前，请阅读本文档中的所有注意事项及安全声明。 和/或 http://support.intel.com/support/motherboards/server/sb/CS-010770.htm 上的

22 Intel® Workstation Board S5000XVNPreparing for the UpgradeThe steps below explain how to prepare to upgrade the BIOS, including how to record the c

Intel® Workstation Board S5000XVN 23Reverting to the Previous BIOSIf you encounter a problem with your BIOS, you may want to revert to the previously

24 Intel® Workstation Board S5000XVNClearing the PasswordIf the user or administrator password(s) is lost or forgotten, moving the password clear jump

Intel® Workstation Board S5000XVN 25Clearing the CMOSIf you are not able to access the BIOS setup screens, the CMOS Clear jumper will need to be used

26 Intel® Workstation Board S5000XVN

3 Hardware Installations and UpgradesBefore You BeginBefore working with your workstation product, pay close attention to the “Safety Information” on

28 Intel® Workstation Board S5000XVN5. Locate the DIMM sockets (see Figure 9).6. Disconnect and remove any components necessary to access the DIMM soc

Intel® Workstation Board S5000XVN 297. Make sure the clips at each end of the DIMM socket(s) are pushed outward to the open position. See letter “A” i

30 Intel® Workstation Board S5000XVNRemoving FBDIMMsTo remove a FBDIMM, follow these steps:1. Observe the safety and ESD precautions in “Safety Inform

Intel® Workstation Board S5000XVN 31Installing the ProcessorNotes:• Do not touch the contacts on either the processor or the processor socket.• Do not

Intel® Workstation Board S5000XVN vWarningsHeed safety instructions: Before working with your workstation product, whether you are using this guide or

32 Intel® Workstation Board S5000XVN6. Disconnect and remove any components necessary to access the processor sockets. See the documentation that came

Intel® Workstation Board S5000XVN 339. If the protective cover is attached from the load plate, remove it and store it for future use.Figure 14. Remov

34 Intel® Workstation Board S5000XVNInstalling the Heatsink(s)Note: The heatsink has thermal interface material (TIM) located on the bottom of it. Use

Intel® Workstation Board S5000XVN 35Use the following steps to install a heatsink.1. Install the processor. See “Installing the Processor” on page 31

36 Intel® Workstation Board S5000XVN5. Active heatsink only: Connect the heatsink cable to the workstation board.Figure 17. Locating Active Heatsink C

Intel® Workstation Board S5000XVN 37Removing a Processor1. Observe the safety and ESD precautions in “Safety Information” on page iii.2. Turn off all

38 Intel® Workstation Board S5000XVN10. Push down on the lever attached to the processor socket. While holding the lever down, pull it towards the cen

Intel® Workstation Board S5000XVN 3912. Lift the processor from the socket. See Figure 15.Caution: Do not touch the contacts on either the processor o

40 Intel® Workstation Board S5000XVN15. Close the load plate.16. Close the socket lever. Push downward on the socket lever while pushing it toward the

Intel® Workstation Board S5000XVN 411. Observe the safety and ESD precautions in “Safety Information” on page iii.2. Turn off all peripheral devices c

vi Intel® Workstation Board S5000XVN

42 Intel® Workstation Board S5000XVN

Appendix A: TroubleshootingThis chapter helps you identify and solve problems that might occur while you are using the system. For any issue, first en

44 Intel® Workstation Board S5000XVNProblems following Initial System InstallationProblems that occur at initial system startup are usually caused by

Intel® Workstation Board S5000XVN 45Hardware Diagnostic TestingThis section provides a more detailed approach to identifying a hardware problem and lo

46 Intel® Workstation Board S5000XVNSpecific Problems and Corrective ActionsThis section provides possible solutions for these specific problems:• Pow

Intel® Workstation Board S5000XVN 47No Characters Appear on ScreenCheck the following:• Is the keyboard functioning? Test it by turning the “Num Lock”

48 Intel® Workstation Board S5000XVNCharacters Are Distorted or IncorrectCheck the following:• Are the brightness and contrast controls properly adjus

Intel® Workstation Board S5000XVN 49Cannot Connect to a Server• Make sure the network cable is securely attached to the correct connector at the syste

50 Intel® Workstation Board S5000XVNThe add-in adapter stopped working without apparent cause• Reseat the adapter.• Put the adapter in a different slo

Intel® Workstation Board S5000XVN 51Problems with Application Software that Ran Correctly EarlierProblems that occur after the system hardware and sof

PrefaceAbout this ManualThank you for purchasing and using the Intel® Workstation Board S5000XVN. Multiple versions of the Intel® Workstation Board S5

52 Intel® Workstation Board S5000XVN• Verify your SAS or SATA drives are connected to the correct ports on the workstation board and the chassis backp

Intel® Workstation Board S5000XVN 53In addition to the beep codes above, additional beep codes are provided if an Intel® Remote Management Module is i

54 Intel® Workstation Board S5000XVN

Appendix B: Regulatory and Compliance InformationProduct Regulatory ComplianceProduct Safety ComplianceThe Intel® Workstation Board S5000XVN complies

56 Intel® Workstation Board S5000XVNCertifications / Registrations / Declarations• UL Certification (US/Canada) • CE Declaration of Conformity (CENELE

Intel® Workstation Board S5000XVN 57Electromagnetic Compatibility NoticesFCC (USA)This device complies with Part 15 of the FCC Rules. Operation is sub

58 Intel® Workstation Board S5000XVNICES-003 (Canada)Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils num

Intel® Workstation Board S5000XVN 59BSMI (Taiwan)The BSMI Certification Marking and EMC warning is located on the outside rear area of the product.RRL

60 Intel® Workstation Board S5000XVNProduct Ecology Change (EU RoHS) Intel has a system in place to restrict the use of banned substances in accordanc

Intel® Workstation Board S5000XVN 61CRoHS Substance Tables China CRoHS requires products to be provided with controlled substance information. Intel u

viii Intel® Workstation Board S5000XVNChapter 4 provides troubleshooting information. In this chapter, you will find BIOS error messages and POST code

62 Intel® Workstation Board S5000XVNChina Packaging Recycle Marks (or GB18455-2001)Intel EPSD has the following ecological compliances:Cardboard and f

Appendix C: Getting HelpWorld Wide Webhttp://support.intel.com/support/motherboards/server/S5000XVN.TelephoneAll calls are billed per incident, levied

64 Intel® Workstation Board S5000XVNIn Asia-Pacific RegionAustralia... 1800 649931Cambodia.. 63 2 636 9797 (via Philippines)China ... 800 820 1

Intel® Workstation Board S5000XVN 65Colombia ... Contact AT&T USA at 01 800 911 0010. Once connected, dial 800 843 4481Costa Rica . Contact AT&

66 Intel® Workstation Board S5000XVN

Appendix D: System Issue Report FormNote: An on-line / automatic submission version of this form is available at http://support.intel.com/support/mot

68 Intel® Workstation Board S5000XVNFBDIMM ConfigurationDIMM A1 MB and vendor / part number: __________________________________DIMM A2 MB and vendor /

Intel® Workstation Board S5000XVN 69Hard Drive InformationControl Panel InformationStandard Control Panel ____________________________________________

70 Intel® Workstation Board S5000XVNComplete Problem DescriptionIn the space below, provide a complete description of the steps used to reproduce the

Intel® Workstation Board S5000XVN ixSee also the Intel® Server Deployment Toolkit 2.0 CD that came with your workstation board.Accessories or other In